Filter
Top Products
DC IN 5V
Socket
16
LOADING THE BATTERY
1
17
CHARGING THE BATTERY
The indicator lamp lights (orange) and battery
charging begins. When charging is completed,
the indicator lamp goes off.
●
!
A fully discharged battery takes about 5 hours to
recharge.
●
!
An almost fully charged battery will not charge. This
is normal and does not indicate a fault.
●
!
If you switch the camera on while the battery is
charging, the charging will stop.
●
!
By using the optional Battery Charger BC-80, you can
reduce the charging time to approximately 70 minutes
(➡P.110).
Check that the camera is switched off. Open the
terminal cover and plug the AC power adapter
connector into the “DC IN 5V” socket. Then plug
the AC power adapter into a power outlet.
●
!
Problems arising from the use of products other than
genuine FUJIFILM products are not covered by your
warranty.
●
!
See P.116, 117 for additional notes on the AC power
adapter.
➀
Hold the battery in,
➁
and close the battery
cover.
●
!
Do not use excessive force to open the battery
cover.
●
!
When replacing the battery, always switch the
camera off beforehand. If you open the battery cover
without switching the camera off, the camera
settings may revert to the factory defaults.
➀
Slide the battery cover and lift it open.
➁
Insert the battery in the direction indicated by
the arrow “” on the battery.
Arrow
mark
1 2
e
NP-80 rechargeable battery.
●
!
The battery is not fully charged at shipment. You
must charge the battery before you use it.
●
!
See P.114 – 116 for more information on the
battery.
◆
Battery Type
◆
●
➁
●
➀
●
➀
●
➁