Filter
Top Products
111
Viewing Images
6
●
!
The camera cannot be used to specify printer settings such
as the paper size and print quality.
●
!
Use an xD-Picture Card that was formatted on the camera.
1Set the “USB/PLAY” switch on the cradle to the
“USB” position.
2Press the “POWER” button on the cradle.
3
01
02
2
1Connect the cradle to the printer using the USB
cable.
2Set the camera into the cradle.
●
!
“PRINT WITH DATE” is not available when the camera is
connected to a printer that does not support date printing.
5
1Press “a” or “b” to select “PRINT WITH DATE”
or “PRINT WITHOUT DATE”. If “PRINT WITH
DATE” is selected, the date is imprinted on your
prints.
2Press the “MENU/OK” button.
01 02
4
“s ” appears and then the menu is
displayed on the LCD monitor.
●
!
If the menu does not appear, check whether the “USB
MODE” setting is
“®”.
●
!
Depending on the printer, some functions are disabled.
110
Always press the “MENU/OK” button after the
settings are completed.
●
!
Press the “DISP (BACK)” button to return to step 5.
6.4.2
Specifying images for printing without using DPOF (single-frame printing)
6.4 CONNECTING THE CAMERA DIRECTLY TO THE PRINTER
— PictBridge FUNCTION
Press the “MENU/OK” button to download the data
to the printer and print the frames specified in the
DPOF settings.
To end printing, press the “DISP (BACK)” button.
●
!
Press the “DISP(BACK)” button to cancel the printing.
Depending on the printer, the printing may not be canceled
immediately or printing may stop midway through. When
printing stops midway, briefly turn the camera off and then on
again.
5
1Press “a” or “b” to select “u PRINT DPOF”.
2Press the “MENU/OK” button.
●
!
When “d” appears, the DPOF settings are not
specified.
●
!
To use DPOF printing, the DPOF settings must be specified
on FinePix F810 beforehand (➡P.76).
●
!
Even when “WITH DATE” is specified in the DPOF settings,
the date is not inserted on printers that do not support date
printing.
01 02
●
!
Do not connect to a PC when the “USB MODE” setting is set
to “
®”. See P.121 if you connect to PC by mistake.
1
1Slide the Power switch to the side to turn the
camera on.
2Select “®” in “USB MODE” in the “SET-UP”
menu (➡P.85).
3Slide the Power switch to the side to turn the
camera off.
01 03
02
6
7
Continued