Filter
Top Products
CONTENTS
Introduction
1 NAMES AND FUNCTIONS OF PARTS
2 BASIC SCANNER OPERATION
3 SCANNING VARIOUS TYPES OF DOCUMENTS
4 DAILY CARE
5 REPLACING CONSUMABLES
6 TROUBLESHOOTING
7 ONLINE SETUP
7.1 Online setup
7.2 Double-feed detection
7.3 Setting of Page Edge Filler
7.4 Setting dropout color
7.5 Setting of pre-pick mode
7.6 Resetting the consumables counters
7.7 Adjusting the offset
7.8 Adjust the magnification
7.9 Power saving
8 DOCUMENT SPECIFICATION OF ADF
9 OPTIONS
10 SCANNER SPECIFICATIONS
Appendix
7.2 Double-feed detection
The settings for the double feed detection are as follows.
1. Click [Device Setting 2] tab, then select [DoubleFeed] from [Preferences].
2. When you select [Check Length] or [Check overlapping and length], select [Length] from 10, 15 or 20mm.
None : The double feed detection will not be performed.
Check Length : The documents length will be monitored.
Check Overlapping : Document overlapping will be monitored.
Length and Overlapping : "Check overlapping and length: The document length (you can select error detection tolerance from 10, 15 or
20mm) and overlapping will be monitored. If the detected length deviation is within the specified tolerance, it will not be detected as an error. "
HINT
Change the double feed configure of the FUJITSU TWAIN32 Scanner driver before you change the double feed configure in the [Software
Operation Panel]. It will take precedence FUJITSU TWAIN32 Scanner driver.
All Rights Reserved, Copyright (C) PFU LIMITED 2003