Filter
Top Products
Chapter 9 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
178
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Specifying the Sensitivity Level for Paper
Protection [Paper Protection Sensitivity]
You can specify the level of sensitivity to detect anomalies
upon feeding the documents when paper protection is
enabled.
Documents are deformed (e.g. warped, bent, creased) when
they are not being fed by the rollers properly. To detect such a
symptom and stop the scan, select [Low] to only detect
documents that are highly deformed, and [High] to also detect
documents that are slightly deformed.
1 Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page 153).
2 From the listing on the left, select [Device Setting 2] J
[Paper Protection Sensitivity].
3 Specify the sensitivity level.
Low : Decreases the sensitivity level to detect warped
documents.
Normal : Monitors the documents in normal sensitivity.
Keep this setting for normal use.
High : Increases the sensitivity level to detect warped
documents.
If paper jams occur frequently, specify [Low].