Filter
Top Products
17
INSTALLATION
CABLE INSTALLATION (INTERFACE SPECIFIC)
RS232
9. Turn on the host system.
10. Scan the Recall Defaults bar code.
The Recall Defaults bar code is located in the MetroSelect Configuration Guide (PN 00-02407x), under Need to Start Over.
11. Configure the StratosH to match the host system’s RS232 parameters.
Refer to the MetroSelect Configuration Guide (PN 00-02407x) under Section G: RS232 for Enabling RS232 Mode (scan
the recall defaults bar code first).
xxx* Specifies international connection. See page 3 for a complete listing of power supply options and their part numbers.
**
See page 3 for information on optional display types and part numbers.
See power source caution statement on page 9 of this manual.
Figure 20. RS232 Interface Cable Installation Schematic