Filter
Top Products
30
SCANNER OPERATION
INDICATOR DESCRIPTIONS
Visual
Steady White and Blue
After a successful scan, the scanner transmits the data to the host device. Some communication modes require that the host inform
the scanner when data is ready to be received. If the host is not ready to accept the information, the scanner’s white LED will remain
on until the data can be transmitted.
Flashing Blue then Flashing White
This indicates the scanner is in configuration mode. A razzberry tone indicates that an invalid bar code has been scanned
in this mode.
Or
If the unit is in sleep mode, each LED will flash once every 15 seconds.
Steady White, Blue Off
This indicates the scanner may be waiting for communication from the host.
Flashing Blue
This indicates there is an error active on the diagnostic indicator display (see Error Codes on page 31). The scanner may continue to
operate depending on the type of error.
Failure Modes
Flashing Blue and One Razzberry Tone
This indicates that the scanner has experienced a laser subsystem failure. The scanner will try up to three times to correct the failure
condition. If the laser subsystem continues to fail, that subsystem (horizontal or vertical) will be shut down and an error indication will
be shown on the Diagnostic Indicator Display. This error stays on the display until corrected. If the remaining subsystem is still
operational, scanning will continue using the operational components.
Flashing Blue and White and Two Razzberry Tones
This indicates that the scanner has experienced a motor subsystem failure. The scanner will try up to three times to correct the
failure condition. If the motor subsystem continues to fail, that subsystem (horizontal or vertical) will be shut down and an error
indication will be shown on the Diagnostic Indicator Display. This error stays on the display until corrected. If the remaining
subsystem is still operational, scanning will continue using the still operational components.
Continuous Razzberry Tone with Both LEDs Off
If, upon power up, the scanner emits a continuous razzberry tone, then the scanner has an electronic failure. Return the unit for
repair at an authorized service center.
Three Beeps – On Power Up
If the scanner beeps three times on power up then, the nonvolatile memory that holds the scanner configuration has failed. Return
the unit for repair at an authorized service center.