Filter
Top Products
35
SCANNER OPERATION
STARTUP
When the scanner first receives power the white LED will flash, the blue LED will turn on and the scanner will beep once
(the white LED will remain on for the duration of the beep). The scanner is now ready to scan.
POWER-UP TEST MODE
When a StratosH scanner is first powered up, it cycles through a number of self-tests before starting normal operation. If there are any
initial failures during this sequence of tests the scanner will beep or razz to indicate the error and an error code will appear in the
diagnostic indicator display.
The following are examples of the types of tests performed at power-up.
1. Memory tests
2. Hardware setup tests
3. Motor tests
4. Laser tests
5. Configuration tests
6. Interface tests
7. Scale tests
These tests are also performed on a periodic basis with the operator alerted to any failures.
CONFIGURATION MODE
All StratosH series scanners have been configured at the factory with a set of default communication protocols. Since many host
systems have unique formats and protocol requirements, Honeywell provides a wide range of configurable features that may be
selected with the use of the MetroSelect Configuration Guide (
PN 00-02407x), the MS2x20 Stratos Series Scanner/Diva Scale
Configuration Addendum (
PN 00-02272x) and MetroSet.