Filter
Top Products
Diagnostics 23
PCNTNW-
NW-086
The driver parameter block is too
small.
Explanation: The driver parameter block
is too small.
Action: Restart the server. If the
problem persists, go to “Starting the
diagnostic programs” on page 11 to run
the diagnostic programs.
PCNTNW-
NW-087
The media parameter block is too
small.
Explanation: The driver media
parameter block is too small.
Action: Restart the server. If the
problem persists, go to “Starting the
diagnostic programs” on page 11 to run
the diagnostic programs.
PCNTNW-
NW-091
The hardware configuration conflicts.
Explanation: You tried to load a new
frame type for the existing controller. The
hardware assumptions made in doing so
are incorrect. This error can also occur if
you try to specify a mode (such as,
redundancy) that conflicts with another
specified mode.
Action: Make sure that the hardware
configuration matches the software
settings.
PCNTNW-
NW-126
The group bit in the node address
override was cleared.
Explanation: The IEEE address has a
group bit that indicates that an address
belongs to a group of stations. This bit is
used only as a destination address; it
cannot be used as a source address. You
tried to enter a source address with this bit
set. The driver cleared the group bit of the
source address.
Action: None necessary, message is for
information only.
Table 2. Novell NetWare or IntraNetWare ODI driver
messages for the Ethernet controller