Filter
Top Products
26 EN D°S°C° RECORDT.{NG
| BasicShooting(D.S.C.Snapshot)
You can use your camcorder as a Digital Still
Camera for taking snapshots. Still images are
stored in the memory card.
NOTE:
Before continuing, perform the procedures listed
below:
• Power (pg. 13)
• Loading a Memory Card ( pg. 17)
• Remove the lens cap.
• Open the LCD monitor fully. (: pg. 8)
SNAPSHOT
Lock Button
Approximate Number of Storable Images
• The number increases or decreases depending
on the Picture Quality/Image Size, etc.
Image Size/Picture SD Memory Card
Quality 8MB 16MB 32MB 64MB
640 x 480/FINE
47 95 205 425
640 x 360/FINE
640 x 480/STANDARD
160 295 625 1285
640 x 360/STANDARD
Image Size/Picture MultiMediaCard
Quality 8MB 16MB 32MB
640 x 480/FINE
640 x 360/FINE 55 105 215
640 x 480/STANDARD
190 320 645
640 x 360/STANDARD
VIDEO/
MEMORY
Power Switch
1 Set the VIDEO/MEMORY Switch to
"MEMORY".
2 Set the Power Switch to "REC" while
pressing down the Lock Button located on the
switch.
• To change the Picture Quality, pg. 31, 33.
3 Press SNAPSHOT.The "PHOTO" indication
appears while the snapshot is being taken.
• To delete unwanted still images, refer to
"Deleting Files"(pg.29).
• When you do not want to hear the shutter
sound, set"MELODY" to "OFF"( pg. 34).
NOTE:
If shooting is not performed for approx. 5 minutes
when the Power Switch is set to "REC" and power
is supplied from the battery pack, the camcorder
shuts off automatically to save power. To perform
shooting again, push back and pull out the
viewfinder again or close and re-open the LCD
monitor.
Appears when you attempt to shoot digital still
images when the write protection tab on the SD
Memory Card is set to the "LOCK" position.
Lvd=hVj[=]=_'d[_:1:ID]_
Appears if there is no memory card loaded when
the sNAPsHOT Button is pressed.