Filter
Top Products
46 ENTROUBLESHOOTXNG
If, after following the steps in the chart below,
the problem still exists, please consult your
nearest JVC dealer.
• I• _ II -o
• The power is not connected properly.
_Connect the AC Adapter securely. ( pg. 13)
• The battery pack is not attached firmly.
_Detach the battery pack once again and re-
attach it firmly. ( pg. 14)
• The battery is dead.
_Replace the dead battery with a fully charged
one.( pg. 13)
I,'_31i'_'_1"_I_ . ,,,. .I_'A
• Focus is set to the Manual mode.
_Set Focus to the Auto mode. ( pg. 37)
• The lens is dirty or covered with condensation.
_Clean the lens and check the focus again.
( pg. 37)
• The light source or the subject does not include
white. Or there are various different light
sources behind the subject.
-l, Find a white subject and compose your shot so
that it also appears in the frame. ( pg. 36, 40)
• The tape's erase protection tab is set to SAVE".
_Set the tape's erase protection tab to "REC".
(pg. 16)
• 'TAPE END" appears.
Replace with new cassette. ( pg. 16)
• The cassette holder cover is open.
_Close the cassette holder cover.
This is not a malfunction.
This is not a malfunction
• Charging is difficult in places subject to
extremely high/low temperatures.
_To protect the battery, it is recommended to
charge it in places with a temperature of 10°C
to 35°C (50°F to 95°F). ( pg. 48)
• The battery pack is not attached firmly.
_Detach the battery pack once again and re-
attach it firmly. ( pg. 13)
• When shooting in the dark, the unit becomes
highly sensitive to light when GAIN UP" is set
to AUTO".
_lf you want the lighting to look more natural set
GAIN UP"to AGC" or OFF".( pg. 33)
• Effects function that cannot be used together
are selected at the same time.
_Re-read the sections covering Effects.
(: pg. 32)
• Your TV has AV input terminals, but is not set to
its VIDEO mode.
-i.Set the TV to the mode or channel appropriate
for video playback. C Pg. 23)
• The cassette holder cover is open.
.,tCIose the cassette holder cover. ( pg. 16)
Clean the video heads with an optional cleaning
cassette.( pg. 5)
• In places subject to low temperature images
become dark due to the characteristics of the
LCD monitor. This is not a malfunction.
-l, Adjust the brightness and angle of the LCD
monitor.( pg. 8, 15)
• When the LCD monitor's fluorescent light
reaches the end of its service life, images on
the LCD monitor become dark.
_Consult your nearest JVC dealer.
• The viewfinder is pulled out and PRIORITY" is
set to "FINDER".
_Push the viewfinder back in or set "PRIORITY"
to LCD".( pg. 8, 34)
• The LCD monitor's brightness setting is too
dark.
_Adjust the brightness of the LCD monitor.
(: pg. 15)