Filter
Top Products
I AudioDubbing
The audio track can be customized only when
recorded in the 12-BIT and SP modes.
( pg. 33)
• Use the provided remote control.
Speaker --
Stereo
Microphone
1 Play back the tape to locate the point where
editing will start, then press PAUSE (11).
2 While holding A. DUB (_ ) on the remote
control, press PAUSE (11).The "11#" indicator
appears.
3 Press PLAY (1_), then begin "narrating".
Speak into the microphone.
• To pause dubbing, press PAUSE (11).
4 To end Audio Dubbing, press PAUSE (11),
then STOP (11).
To hear the dubbed sound during playback
Set "NARRATION" to "ON" or "MIX"
( - pg. 35).
NOTES:
• Sound is not heard from the speaker during
Audio Dubbing.
• When editing onto a tape that was recorded at
12-BIq_ the old and new soundtracks are
recorded separately.
• Iffeedback or howling occurs during TV
playback, move the carncorder's microphone
away from the TV, or turn down the TV's volume.
EDITING EN 45
I InsertEditing
You can record a new scene into a previously
recorded tape, replacing a section of the
original recording with minimal picture
distortion at the in and out points.The original
audio remains unchanged.
• Use the provided remote control.
NOTES:
• Before performing the following steps make
sure that "TIME CODE" for DISPLAY" in both
Recording and Playback Menus is set to ON".
( pg. 34 35)
• Insert Editing is not possible on a tape recorded
in the LP mode or on a blank portion of a tape.
1 Play back the tape, locate the Edit-Out point
and press PAUSE (11).Confirm the time code
at this point. (:" pg. 20)
2 Press REW (4141) until the Edit-in point is
located, then press PAUSE (11).
3 Press and hold INSERT (o) on the remote
control, then press PAUSE (11).The "llq,_,"
indicator and the Time Code (min.:sec.)
appear and the camcorder enters Insert-Pause
mode.
4 Press START/STOP to begin editing.
• Confirm the insert at the time code you checked
in step 1.
• To pause editing press START/STOP. Press it
again to resume editing.
5 To end Insert Editing, press START/STOP,
then STOP (11)on the remote control.
Z
NOTES: >_
• Program AE Effects and Shutter Effects
(pg. 41) can be used to spice up the scenes
being edited during Insert Editing.
• During Insert Editing, the date and time
information changes.
• Ifyou perform Insert Editing onto a blank space
on the tape, the audio and video may be
disrupted. Make sure you only edit recorded
areas.
• During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Editing stops.