Filter
Top Products
I ubbingToOr FromA VideoUnit
EquippedWith A DV Connector
(Digital Dubbing)
It is also possible to copy recorded scenes
from the camcorder onto another video unit
equipped with a DV connector. Since a digital
signal is sent, there is little, if any. image or
sound deterioration.
To DV IN/OUT
DV cable (optional)
_, To DV IN/OUT
Video unit equipped with DV connector
To use this camcorder as a player
1 Make sure all units are turned off.
2 Connect this camcorder to a video unit
equipped with a DV input connector using a DV
cable as shown in the illustration.
3 Start playback on the camcorder.
("pg.21)
4 At the point you want to start dubbing, start
recording on the video unit. (Refer to the video
unit's instruction manual.)
5 To stop dubbing, stop recording on the
video unit, then stop playback on this
camcorder.
ED.[T.[NG EN 43
NOTES:
• It is recommended to use the AC Adapter as
the power supply instead of the battery
pack.( pg. 13)
• Ifa blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not
dubbed.
• Even though the DV cable is connected
correctly, sometimes the image may not appear
in step 4. If this occurs, turn off the power and
make connections again.
• If"Playback Zoom" ( "pg. 25) or Playback
Special Effects" ( "pg. 25) is attempted or
SNAPSHOT is pressed during playback, only
the original playback image recorded on the
tape is output from the DV IN/OUT connector.
• When using a DV cable, be sure to use the
optional JVC VC-VDV204U or VC-VDV206U
DV cable.
To use this camcorder as a recorder
1 Make sure all units are turned off.
2 Connect this camcorder to a video unit
equipped with a DV output connector using a
DV cable as shown in the illustration.
3 Set the camcorder's Power Switch to
"PLAY".
4 Set "REC MODE" to "SP" or "LP".
( "pg. 35)
5 Start playback on the player.
6 Press the Recording Start/Stop Button to
engage the Record-Pause mode.
• The" B_]N "indication appears on the
screen.
7 At the point you want to start dubbing,
press the Recording Start/Stop Button to start
dubbing.The _ indication rotates.
8 Press the Recording Start/Stop Button
again to stop dubbing.The _ indication
stops rotating.
9 Press • to return to the normal playback
mode.
NOTE:
Digital Dubbing is performed in the sound mode
recorded on the original tape regardless of the
current SOUND MODE" setting. ( "pg. 33)
Appears if dubbing of copyguarded signals is
attempted while this camcorder is being
used as a recorder.
Z