Filter
Top Products
27
EN
BRACKETING
Records 5 continuous images from dark
(-0.6EV) to bright (+0.6EV) based on the
brightness of still images set in AUTO or
MANUAL.
After performing steps 1-2
3 Press SNAPSHOT.
NOTE
•
When there is no SD, or when there is no
remaining space on the SD card, it is not
possible to save still images.
•
When the continuous shooting or bracketing
indicator is blinking, do not set Scene Select
to [PORTRAIT], [NIGHT & PORTRAIT], or
[SPORTS]. (Z p. 37)
•
When Scene Select (Z p. 37) is set
to [TWILIGHT], [SLEEPING FACE], or
[FIREWORKS], the continuous shooting
speed is slow.
Turning on the Face Detection Mode
If you set this mode on, the camera detects the
faces and adjust brightness and focus so that
the faces are recorded clearly.
Preparation:
•
Select the recording mode.
•
Select ! or # mode.
Select .
To turn off the face detection mode
Select again.
Recording still images with the face
detection mode turned on
1 Press and hold SNAPSHOT halfway.
2 Press SNAPSHOT.
Using the self-timer in the face detection
mode
Preparation:
Set [SELF-TIMER] to [FACE DETECTION].
1 Press SNAPSHOT.
Faces are detected.
2 The still image is recorded 3 seconds
after the face of the photographer is
detected.
Photographer
NOTE
•
If the LCD monitor is turned upside down,
is not displayed. Change the setting when
the LCD monitor is in the normal position.
•
You cannot turn on the face detection mode if
[SELF-TIMER] is set to [FACE DETECTION].
(This is indicated by blinking .)
•
Depending on the condition, faces may not
be detected.
•
If the face detection does not work correctly,
turn off the mode before recording.