Konica Minolta APS Camera Digital Camera User Manual


 
7574
TITLE IMPRINTING
1. Open the control-panel
door and press the title
button to select the
desired title.
Each press of the title button
changes the title to the next
selection.
You can choose a title for the entire roll of film. Both the
filmstrip title and the frame title will be imprinted on the back of
the photograph.
The filmstrip title will be imprinted on the back of every print.
Filmstrip Title Imprinting
After the film has been
rewound and is blinks in
the data panel-
2. Press the shutter-release
button all-the-way down
to set the title.
SELF
-
TIMER
1. Place the camera on a
tripod, then press the self-
timer button, until
appears in the data panel.
2. Center your subject in the
focus frame.
The self-timer will delays the release of the shutter for
approximately 10 seconds after the shutter-release button is
pressed.
The self-timer mode will automatically cancel after the shutter
is released.
Do not press the shutter-release button while standing in front
of the camera.
If you want to take a picture with your subject outside of the
focus frame, use focus hold. See page 38.
To cancel the self-timer before the shutter releases, press the
main switch to turn the camera off, or press the self-timer
button.
3. Press the shutter-release
button all-the-way down
to start the timer. The self-
timer indicator on the
front of the camera will
blink, then glow just
before the shutter
releases.
3. When blinks in the data panel again, press the
film-chamber release and remove the film.
Set the filmstrip title before removing the film. Once the film
has been removed, a filmstrip title can not be recorded.
Once set, the filmstrip title can not be changed or canceled
using the camera.
Filmstrip titles set on rolls rewound at mid roll will appear on
frames exposed after reloading.
A filmstrip title can not be set on a reloaded partially exposed
roll.