Filter
Top Products
8180
Eyepiece Cup
Eyepiece Cap
BULB
Bulb can only be used in M
mode. When set, the shutter will
remain open as long as you
press the shutter-release
button. To avoid blurry pictures,
mount the camera on a tripod
and use the optional IR Remote
Control RC-3 to release the
shutter.
2. Turn the control dial until
bulb appears in the data
panel.
1. Select M mode.
3. Press and hold the
exposure-compensation/
aperture button, then turn
the control dial to set the
aperture.
4. Mount the camera on
tripod and compose the
picture.
5. Remove the eyepiece cup.
1. Press the • button to open the shutter immediately,
or press the 2s button to delay the release for two
seconds.
2. Press either button to close the shutter.
When using the IR Remote Control RC-3
7. Press and hold the shutter-release button to take the
picture.
•The shutter will remain open until the shutter-release button is
released.
•The shutter speed data on the back of the print will be
recorded as 100 seconds.
6. Slide the eyepiece cap on.
•The eyepiece cap prevents
stray light from entering the
eyepiece and affecting
exposure.