Konica Minolta DiMAGE E203 Digital Camera User Manual


 
14
GETTING UP AND RUNNING
This camera is equipped with a zoom lens. The effect of
the zoom is visible in the viewfinder and on the LCD
monitor.To activate the LCD monitor, simply press and
hold the display button.
The controller is used to zoom the lens.
Pressing the up key of the controller zooms the
lens toward the telephoto position (T).The
down key zooms towards the wide-angle posi-
tion (W).
USING THE ZOOM LENS
Controller
Display button
Center the subject within the viewfinder focus frame.
For off-center subjects, use the focus-lock function (p. 15).
Make sure the subject is within the focus range of the lens:
0.8m – '. For subjects closer than 0.8m, use the macro
function (p. 20).
The actual autofocus sensor is located in a
small area within the focus frame as
illustrated on the right by the shaded box.
Press the shutter-release button partway down (1) to lock the focus and exposure.
The green focus lamp next to the viewfinder will glow to confirm that the image
is in focus. If the focus lamp blinks, the camera was unable to focus on the
subject. Repeat the previous steps until the lamp is
steady.
Press the shutter-release button all the way down (2) to take the pic-
ture.
Both the focus and flash lamps will glow indicating the image data
is being written to the memory card. Never
remove a memory card while data is being
transferred.
After an image in recorded, it can be
played back for three seconds by activating
the instant-playback function on the setup menu (p. 38, 41)
With the mode dial set to auto recording, the camera will turn on and the lens
will automatically extend. If the lens is hindered when extending, an error mes-
sage (Err) will appear on the data panel; turn the camera off and wait for the
lens to retract.
1
2
BASIC RECORDING OPERATION