Filter
Top Products
CONNECTING THE CAMERA TO A COMPUTER
When the camera is properly connected to the computer, a drive icon will appear. Double click on the
icon to access the camera’s memory card; see page 45. If the computer does not recognize the cam-
era, disconnect the camera and restart the computer. Repeat the connection procedure above.
Start up the computer.
• The computer must be turned on before connecting the camera.
Insert the memory card into the camera.
• Confirm that the correct card is in the camera.To change the memory card while the camera is
connected to a computer, see page 48.
Attach the other end of the USB cable to the computer’s USB port.
• Make sure the plug is firmly attached.
• The camera should be connected directly to the computer’s USB port. Attaching the camera to
a USB hub may prevent the camera from operating properly.
A fresh set of batteries should be used when the camera is connected to a computer.The use of the
AC adapter (sold separately) is recommended over the use of batteries. For users with Windows 98,
read the section on installing the necessary USB driver before connecting the camera to a computer
(p. 44).
Turn the mode dial to the playback position or a recording position to initiate the USB connection.
• “PC” will be displayed on the frame counter of the data panel.
1
2
3
4
5
Attach the smaller plug of the USB cable to the camera’s USB port.
• Make sure the plug is firmly attached.