Filter
Top Products
46
PC MODE
DISCONNECTING THE CAMERA FROM THE COMPUTER
Confirm that the access lamp is not lit. Turn the camera off and then disconnect the USB cable.
WINDOWS 98 AND 98SE
Confirm that the access lamp is not lit and then drag the mass-storage device icon and drop it into
the trash.
Disconnect the USB cable.
• If the USB cable is disconnected before performing the first step, an alert message will appear.
Always complete the first step before disconnecting the USB cable.
MACINTOSH
Never disconnect the
camera when the access
lamp is lit – the data or
memory card may
permanently be damaged.
AUTO POWER OFF (PC MODE)
If the camera does not receive a read or write command within thirty minutes, it will shut down to
save power.When the camera shuts down, an unsafe-removal-of-device warning may appear on the
computer monitor. Click “OK.” Neither the camera or computer will be damaged in this operation.
To reconnect the camera to the computer is simple.Turn off the camera with the mode dial. Remake
the USB connection by turning the mode dial back to the playback or recording position.