Filter
Top Products
24 Recording - basic operation
Place the subject anywhere within the focus frame. Make sure the
subject is within the focus range of the lens (p. 26). If the subject is
closer than 1m (3ft.) at the zoom lens’ wide-angle position or 3m
(10ft) at the telephoto position, use the LCD monitor to frame the
subject.
BASIC RECORDING OPERATION
Slide the mode switch to the digital-subject-program or recording
position. The operation for both modes is the same. Automatic
Digital Subject Program Selection is only active in the digital-sub-
ject-program mode.
Press the shutter-release button partway down to lock the focus and
exposure. Automatic Digital Subject Selection will choose the appro-
priate exposure mode, see the facing page.
The monitor focus signal is white and viewfinder indicator lamp
turns green to confirm focus lock. If the focus signal is red or the
indicator lamp blinks, the camera was unable to locate the subject.
Repeat the previous steps.
Press the shutter-release button all the way down to take the pic-
ture. The recorded image can be previewed by continuing to hold
down the shutter-release button after the image is captured. The
instant-playback function can also be used (p. 47).
The viewfinder indicator lamp turns red and blinks indicating data is
being written to the memory card. Never remove a memory card
while data is being transferred.
Focus
signal