Filter
Top Products
37
DRIVE MODES
The drive modes control the rate and method images
are captured. Indicators indicating the selected drive
mode appear on the monitor. If auto reset (p. 45) is
active, the drive mode is reset to single-frame advance
when the camera is turned off.
Press the down key of the controller to select the drive
mode (1).
Single-frame advance - to take a single image each time the shutter-release but-
ton is pressed. This is the camera’s default setting.
Self-timer - to delay the release of the shutter (p. 38). Used for self-portraits.
Multi Frame - to create a composite image of a nine-frame series when the shut-
ter-release button is pressed once, see below.
Continuous advance - to take up to four images when the shutter-release button
is pressed and held (p. 39).
UHS continuous advance - to take eleven 1280x960 size images in one second
when the shutter-release button is pressed and held (p. 39).
Multi Frame
Take the picture as described in the basic recording operation sec-
tion (p. 24). Once the series starts, the shutter button can be
released; the camera continues recording until all nine frames have
been captured.
Flash cannot be used. Because of the limits to the shutter speeds,
images may be underexposed in low-light conditions. Image size
refers to the total area of all nine images, not the size of each indi-
vidual thumbnail.
1