Filter
Top Products
75
Operating step
1. Using the slider (13) on the left of the camera, release and
open the back cover (17).
Note: Take this opportunity to check whether there is any
dust on the rear lens element. If so, it should be removed
with a soft brush.
2. Place the film cartridge in the film cartridge compartment
(31) as shown. The sprung spindle on the rewind axle (32)
must engage with the corresponding slot in the film car-
t
ridge.
3. Lay the film flat on the film channel, between the guides
(29) and pull the leader right over the take-up spool (28) –
as shown in the illustration – up to the marking to the left
(arrow). If you have taken the leader too far, carefully push
a little film back into the cartridge. The film must lie flat in
the film channel.
Displays in the data panel
0
in frame counter, otherwise unchanged
Note: When the camera is turned off, the date display and the
set exposure control mode do not appear.
Constant
Constant
English