Filter
Top Products
121
• Mini Driver not found. (DS41012)
Cause: The Mini driver may not have been installed, or may have been
deleted.
R
esolution: Install the mini-port driver following the instructions mentioned in
“3.2 Installing Scanner Driver”.
• Scanner DLL file not found. (DS41004)
Cause: An image scanner was selected, but the DLL file of the selected image
scanner has not been installed in the directory in which this driver is
installed.
R
esolution: Perform the setup again.
• A parameter error has occurred (internally) (DS50001)
• The calling procedure is invalid (internally). (DS50002)
• The area is specified incorrectly (internally). (DS50003)
• The calculation result exceeded the value that can be expressed (internally). (DS50004)
• User definition is not registered (internally).
• Illegal value is received during communication with scanner. (internally). (DS41008)
Cause: This is a program error that occurs during command exchange
between the driver and the image scanner.
R
esolution: Try again by rebooting the machine. If the error persists, contact the
retail store where the product was purchased or the nearest service
center.
• A general fault of the MSG_XXXXX response (internally). (DS50150 ~ DS50185)
Cause: This is a program error that usually occurs during internal message
transfer. This message involves the sub-messages described later.
R
esolution: Contact the retail store where the product was purchased or the
nearest service center.
• A general fault of the DAT_XXXXX response (internally). (DS50006 ~ S50077,DS50096
~ DS50150)
Cause: This is a program error that usually occurs during internal data
transfer. This message involves the sub-messages described later.
R
esolution: Contact the retail store where the product was purchased or the
nearest maintenance service center.