Filter
Top Products
E92
Reference Section
Error Messages
Display Cause/Solution
A
O (flashes)
Clock not set.
Set date and time.
E66
Battery exhausted. Charge or replace battery. 16, 18
Battery temperature
high
Battery temperature is high.
Turn off camera, and allow battery to cool down before
resuming use. After five seconds, this message will
disappear, the monitor will turn off, and the power-on
lamp will flash quickly. After the lamp flashes for three
minutes, the camera will turn off automatically. Pressing
the power switch also turns off the camera.
23
The camera will turn
off to prevent
overheating.
Inside of the camera has become hot.
Turn off camera, and allow battery to cool down before
resuming use.
–
Q (● flashes red)
Camera cannot focus.
• Refocus.
• Use focus lock.
30, 31
76
Please wait for the
camera to finish
recording.
Camera cannot perform other operations until saving is
complete.
Wait until message clears from display automatically
when saving is complete.
–
Memory card is write
protected.
Write-protect switch is in “lock” position.
Slide write-protect switch to “write” position.
–
Not available if Eye-Fi
card is locked.
Write-protect switch of Eye-Fi card is in “lock” position.
Slide the write-protect switch to “write” position.
–
Error accessing Eye-Fi card.
• Use an approved card.
• Check that terminals are clean.
• Confirm that Eye-Fi card is correctly inserted.
E84
20
20
This card cannot be
used.
Error accessing memory card.
• Use approved card.
• Check that terminals are clean.
• Confirm that memory card is correctly inserted.
21
20
20
This card cannot be
read.