Filter
Top Products
90
Windows
Windows 98 Second Edition (SE)
Before You Begin
Confirm that your OHCI-compliant IEEE 1394 interface board or card has been correctly regis-
tered with the system.
Click the My Computer icon on the desktop
with the right mouse button and select Prop-
erties from the menu that appears. The Sys-
tem Properties dialog will be displayed; click
the Device Manager tab.
If “1394 Bus Controller” is not listed in the Device Manager, or if your IEEE 1394 interface
board or card is listed as an unknown or miscellaneous device or is preceded by a red or yellow
warning icon, follow the instructions in the manual provided with the board to ensure that the
drivers are properly installed.
After installing Nikon Capture 3 and restarting the computer, connect your camera to the
computer using an IEEE 1394 cable and turn on the camera. The camera is registered auto-
matically.
Follow the instructions below to check that the camera has been correctly registered with the
system.
Step 1
Once registration is complete, check that the D1
X
(or D1 or D1
H
) has been correctly registered with
the system. Click the
My Computer icon on
the desktop with the right mouse button and
select Properties
from the menu that appears.
The System Properties dialog will be displayed;
click the Device Manager tab.
Updating the Drivers for the D1
If you are already using the D1 with Nikon View DX or an earlier version of Nikon Capture, you will need
to update the camera drivers as described below in “Updating the Drivers for the D1.”
Before Connecting the Camera
Be sure to install Nikon Capture 3 before connecting your camera to the computer.
The bus controller for
your IEEE 1394 board or
card should be listed un-
der “1394 Bus Controller.”