Filter
Top Products
15
First Steps
Read Battery Warnings
Read and follow the battery warnings and cautions on pages ii–iv and 150 of
this manual, together with any warnings and instructions supplied by the bat-
tery manufacturer.
Replacing Batteries
Before removing or inserting batteries, make sure that the camera is off. Do not open
the battery chamber cover while the power-on lamp is lit. To remove the battery,
open the battery chamber cover as described in Step 2 on the preceding page and
slide the battery out.
Alternative Power Sources
• To power the camera continuously for extended periods, use an EH-53 AC adapter
or an EH-21 AC adapter/battery charger ( 148), which doubles as a battery charger
for EN-EL1 batteries. Do not, under any circumstances, use another make or
model of AC adapter. Failure to observe this precaution could result in overheating
or in damage to the camera.
• The camera can also be powered by a six-volt 2 CR5
(DL245) lithium battery. We recommend buying
2CR5 (DL245) batteries as a back-up power source.
Insert 2CR5 batteries as shown at right.
E
N
-E
L
1
2
C
R
5