Filter
Top Products
84
Viewing Pictures on a Computer
More on Playback
Connecting the USB Cable
Turn the computer on and wait for it to start up. After confi rming that the
camera is off, connect the UC-E1 USB cable as shown below. Connect the
camera directly to the computer; do not connect the cable via a USB hub or
keyboard.
Windows 2000 Professional, Windows Millennium Edition (Me),
Windows 98 Second Edition (SE), Mac OS 9 (9.0–9.2)
Do
NOT select PTP when connecting the camera to a computer running one of the
above operating systems. If the camera has been connected to a computer running
one of the above operating systems with PTP selected in the USB menu, disconnect
the camera as described below. Be sure to select Mass storage before reconnecting
the camera.
Windows 2000 Professional
The computer will display the welcome dialog for the Found New Hardware Wizard.
Click Cancel to close the dialog, and then disconnect the camera.
Windows Millennium Edition (Me)
After displaying a message stating that the hardware information database is being
updated, the computer will start the Add New Hardware Wizard. Click Cancel to exit
the wizard, and then disconnect the camera.
Windows 98 Second Edition (SE)
The Add New Hardware Wizard will be displayed. Click Cancel to exit the wizard, and
then disconnect the camera.
Mac OS 9 (9.0–9.2)
A dialog will be displayed stating that the computer is unable to use the driver needed
for the “Nikon Digital Camera E5400_PTP” USB device. Click Cancel to close the
dialog, and then disconnect the camera.
Turn the camera on and transfer pictures as described on the reverse side of
the Quick Start Guide.
UC-E1 USB cable
Digital I/O connector
tilts upwards slightly