Filter
Top Products
170
E
OK
SET
3
You can select a series of pictures to be direct-
printed to the P-300 printer.
1 Connect the camera with the printer, turn on the power,
then press the Function button in the Display mode to
select the Random Print mode.
2 Select frames with the +/– buttons and press the OK
button at each picture to be printed.
● When the OK button is pressed for three seconds, the
camera produces a beep sound and enters the All-Frame
print mode. When the button is held down for another two
seconds, the camera produces the beep sound again and
erases the selection data.
3 Enter the number of copies to be printed on the printer,
then press the DIRECT PRINT button to start printing.
● See page 164 for connection to the printer.
RANDOM PRINT
◆ This mode is available only when the camera is
connected to the P-300 printer.
◆ The data for the Random Print are stored in the
card even after printing.
◆ Canceling the Print mode or turning off the
power erases the Random Print request.
◆ The use of the optional AC adapter is
recommended.
Note:
Press for 3 seconds — All print
Press for 5 seconds — All cancel
Touche maintenue enfoncée durant 3 secondes :
impression de toutes les données.
Touche maintenue enfoncée durant 5 secondes :
effacement de toutes les données.
Presione durante 3 segundos — Impresión completa
Presione durante 5 segundos — Cancelación de la
selección
+/– buttons
Touches (+/–)
Botones +/–
LCD Monitor
Écran ACL
Monitor LCD
OK button
Touche OK
Botón OK
Function button
Touche de fonction
Botón de función