Filter
Top Products
200
E
The pictures already taken do not appear on the LCD
monitor.
1 The lens barrier has been left open.
[ Close the lens barrier and depress the LCD monitor
ON/OFF button to turn on the LCD monitor. (P. 130)
2 There is no picture in the SmartMedia
[ Check the number of storable pictures. (P. 64)
The LCD monitor is hard to read.
1 The brightness may be incorrectly set.
[ Adjust the brightness. (P. 162)
When the camera is connected to a computer, an error
message appears while data is being transferred to the
computer.
1 The cable is not plugged in correctly.
[ Connect the cable correctly. (P. 186)
2 The power is OFF.
[ Open the lens barrier to turn on the power. (P. 60)
3 The batteries are exhausted.
[ Replace the batteries with new ones (P. 52) or use the
optional AC adapter (P. 54).
4 The serial port is not selected correctly.
[ Use the operating system software to make sure the
serial port is selected correctly.
5 There is no available serial port.
[ Make one available by following the computer’s
instructions.