![](http://pdfasset.owneriq.net/7/be/7befed2d-3188-a4b4-51cb-5d240ddd6a2b/7befed2d-3188-a4b4-51cb-5d240ddd6a2b-bg6d.png)
109
Correcting the amount of light produced by the
flash — Flash intensity control
You can adjust the amount of light emitted by the flash to correspond with
your shooting requirements.
1
Press to display Menu.
2
Press on the Arrow pad to
select , then press .
3
Press to increase/decrease
the amount of light emitted.
● appears on the control panel.
● Use to increase/decrease the
value.
: The exposure is corrected by a
+1/3 EV step with each press.
: The exposure is corrected by a
–1/3 EV step with eachpress.
● Correction can be made within a
range of ±2EV (ExposureValue).
4
Press the OK button.
● The setting is stored in memory
and the Menu disappears.
2, 3
4
1
[
2/5
]
F2.8 1/800 0.0 P
BKT
MULTI
METERING
SLOW
0
Control panel
Flash intensity control
● If the FL-40 extension flash is set to TTL-AUTO and used simultaneously
with the main flash, correction is made for the amount of light emitted by
both flashes.
● If the FL-40 external flash is set to MANUAL and used simultaneously with
the main flash, correction is made only for the amount of light emitted by the
main flash only.
● The flash correction effect may not be sufficient if the shutter speed is too fast.
Note: