Filter
Top Products
197
SYMPTOM
The monitor is not clear.
POSSIBLE CAUSES
1The brightness is not
adjusted properly.
2The monitor is exposed
to direct sunlight.
CORRECTIVE ACTION
1Adjust the brightness.
2Block the sunlight.
REF. PAGE
P. 163
SYMPTOM
Image rotate, Image protect, Single-erase, All-frame erase and Card
formatting cannot be performed.
POSSIBLE CAUSES
1A write-protect adhesive
seal is affixed to the
card.
CORRECTIVE ACTION
1Use the card after peeling off
the seal. Do not reuse the
write protect seal.
REF. PAGE
P. 43
SYMPTOM
When the camera is connected to a computer, an error message appears
while data is being transferred to the computer.
POSSIBLE CAUSES
1The cable is not plugged
in correctly.
2The power is OFF.
3The batteries are
exhausted.
4The serial port is not
selected correctly.
CORRECTIVE ACTION
1Connect the cable correctly.
2Turn on the camera, then set
the Mode dial to .
3Replace the batteries with
new ones or use the optional
AC adapter.
4Use the operating system
software to make sure the
serial port is selected
correctly.
REF. PAGE
P. 182–187
P. 187
P. 33–38