Filter
Top Products
97
Compensating for image blur — Stabilization system
When you take pictures with at wide-angle or telephoto, camera shake is more
likely to affect the picture, causing image blur. If this happens to you, you can
compensate for camera shake with the camera shake prevention feature.
Under some conditions, may not work effectively.
•When the camera angle is changed very quickly
•Night-scene recording
•Overexposure
•When the battery indicator is blinking
1
Press to display Menu.
2
Press on the Arrow pad to
select , then press .
When appears, press to
select ON, then press the OK
button.
●
To go back to the normal screen, press
the OK button again. The setting is stored.
3
Press the Shutter button halfway.
● It takes about for 1 sec. to stabilize the
image after setting. Check the image on
the screen.
4
Press the Shutter button all the
way down.
●
This mode does not work effectively if you
press the Shutter button all the way down
soon after pressing it halfway down.
● If the shutter speed is low (p.110), this
mode does not function.
● Since the Stabilization system remains
activated for approx. 2 sec. after a picture
is taken, you do not have to wait until the
image is stabilized during Sequential
shooting.
૽૽
This mode is not suitable in the
following cases
●When using a tripod.
●When using a cinepanhead
●When using a conversion lens
3, 4
2
1
2
[
1/5
]
F2.8 1/800 0.0 P
ISO
WB
DIGITAL
ZOOM
OFF
ON
Menu (still picture recording mode)
Control panel
Stabilization system