Filter
Top Products
48
Screen displays (continued)
(Continued on the next page)
C ■
CANNOT BE USED DUE TO INCOMPATIBLE
DATA.
No use is possible because the standard for the
data is different.
CANNOT DELETE.
Clip cannot be deleted.
CANNOT DELETE WITH THIS BUTTON
Clip cannot be deleted.
CANNOT PLAY.
No playback is possible.
CANNOT PLAY WITH THIS BUTTON
No playback is possible.
CANNOT RECORD PH MODE AND HA MODE
INTO THIS CARD.
This card cannot be recorded to in PH mode or
HA mode.
CANNOT RECORD.
THE NUMBER OF CLIPS HAS EXCEEDED
THE MAXIMUM LIMIT.
The maximum number of clips has been reached
and no further clips can be recorded.
CANNOT SET
THE NUMBER OF INDEXES HAS EXCEEDED
THE MAXIMUM LIMIT.
No further indexes can be set because the
number of indexes will exceed the maximum
limit.
CANNOT SET PRE-REC,
CARD CAPACITY TOO LOW.
PRE-REC cannot be set as the remaining card
capacity is low.
CARD DOOR OPENED.
The card door is open.
CARD ERROR.
PLEASE REFORMAT.
Formatting has failed. The card needs to be
reformatted.
CARD FULL.
The card is full.
CHECK CARD.
Please check the card.
If an SD memory card that has been used before
in another device or personal computer is used
for the first time in this camera-recorder, CHECK
CARD is displayed, and all operations may be
disabled. In such a case, perform the following:
1 Remove the SD memory card from the unit
and insert it again. (Page 38 of Vol.1)
The unit recognizes the SD memory card and
cancels the CHECK CARD display.
2 If the CHECK CARD display is not canceled
even after removing and inserting the SD
memory card several times, check the
contents of the card on a personal computer,
and erase the entire data.
3 Format the SD memory card in the unit. (Page
36 of Vol.1)
If the data on the card cannot be either read or
erased on a personal computer, the SD memory
card may be corrupted. Use another SD
memory card.
CHECK USB CABLE.
Please connect the camera-recorder to a PC.
CONTROL DATA ERROR HAS BEEN
DETECTED.
An error has been detected in the control
information.
D ■
DISCONNECT USB CABLE.
When switching from one mode to another,
disconnect the USB connection cable.
I ■
INCOMPATIBLE CARD.
PLEASE CHECK CARD.
This card may have been formatted in a format
with different system frequency. Check the card.
Main warning displays
The main warning displays appearing on the LCD monitor or viewfinder are listed below. If a warning
display is not listed, check carefully the message displayed.