Filter
Top Products
6
Marker
If you press the ZEBRA button while the zebra
pattern is being displayed, a marker appears in
the center of the display (if you have set the setup
menu, DISPLAY SETUP, MARKER to ON).
The brightness of the areas near the screen center
can be checked as a percentage (0% to 99%).
“99%↑”appearsifthepercentageisover99.
99%
Image level detection area
Image level
Marker
The normal display reappears if you press the
ZEBRA button again.
Checking and displaying shooting status
MENU
START/
STOP 2
PUSH-ENTER
MODE
POWER
DISP/
MODE
CHK
USER 1
USER 2
FUNCTION
FOCUS
IRIS
GAIN
WHITE BAL
B
PUSH AUTO
MEGA
ON
OFF
O.I.S.
CAM
ON
CH1
CH2
AUDIO
LEVEL
..
OFF
PB
+–
AUDIO MON
EXEC
A
PRST
L
M
H
A
M
DISP/MODE CHK button
Pressing the DISP/MODE CHK button during
recording or while recording is paused will remove
all displays from the screen except the operation
status display, frame display (such as area),
counter, marker, and safety zone display.
Pressing the DISP/MODE CHK button during
recording or while recording is paused will
remove all displays from the screen except for the
operation status, frame display erea etc., counter,
marker, and safety zone display. Press the button
again to return to the normal display. (Page 50)
This setting will be maintained even if the camera’s
power is turned off by moving the POWER switch to
the OFF position or if the operating mode is changed.
Pressing the DISP/MODE CHK button while the
thumbnail screen is displayed in PB mode will
display the properties of the selected clip.
(Clips can be selected by moving the cursor with
the Operation lever.)
Shooting techniques for different targets (continued)
PRE REC
Record video and audio from three seconds before
the time of the operation to begin recording.
Operation to start
recording
Operation to stop
recording
Actual recording
time
PRE REC time
(Time)
1
Set the PREREC MODE item on the
RECORDING SETUP screen to ON.
PRE-REC will be displayed on the screen.
When the TCG item on the TC/UB SETUP •
screen has been set to REC RUN, the setting
will be automatically changed to FREE RUN.
2
Press the START/STOP button.
Video and audio from approximately 3 seconds
previously will be recorded.
Recording of the previous 3 seconds of video •
and audio may not be possible if recording is
started immediately in the following cases.
Immediately after switching from PB mode ā
to CAM mode
Immediately after turning power on ā
Immediately after changing to PREREC ā
MODE item
The thumbnail for clips recorded using the •
PREREC function will display the image from
when the START/STOP button was pressed.
Relay function
When the remaining space on an SD card is
insufficient during recording, recording can be
continued using the other SD card slot.
Select ON in the RELAY REC item on the settings
menu RECORDING SETUP screen.
When the remaining space on an SD card is •
insufficient during recording, recording will
automatically be continued using the SD card in
the other slot.
The relay function is not available when an SD •
card that cannot be recorded to is inserted in the
SD card slot.
The longest possible recording time with this •
camera is 12 hours. This cannot be extended
even if the relay function is used.