Filter
Top Products
17
Shooting
During shooting, you can record up to two
channels of sound. You can also switch the input
sound to be recorded on each of the channels to
the built-in microphones, external microphones or
audio equipment connected to camera.
POWER
FOCUS
..
BARS
EVF DTL
CH1 SEL
INT
(
L
)
ON
OFF
ON
OFF
INPUT1
AUDIO
MIC POWER +48V
INPUT1 INPUT2
INPUT2
INPUT1
INPUT2
CH2 SEL
WFM
COUNTER-RESET/TC SET
ZEBRA OIS
CH1 SELECT switch
CH2 SELECT switch
INPUT 1/2
(MIC POWER +48V)
switches
INPUT 1 switch
INPUT 2 switch
INPUT 1 terminal INPUT 2 terminal
Switching Audio Input
Using the built-in microphone
1
Switch the CH1 SELECT switch to INT (L).
Audio from the built-in microphone Lch is •
recorded to audio channel 1.
2
Switch the CH2 SELECT switch to INT (R).
Audio from the built-in microphone Rch is •
recorded to audio channel 2.
Using an external microphone and
audio equipment
1
Connect an external microphone or audio
equipment to the INPUT 1/2 (XLR 3-pin)
terminals. (Page 41)
2
Use the INPUT 1/2 switches to switch the
audio input.
LINE: (audio equipment is connected)
Input level is 0 dBu.
MIC: (an external microphone is connected)
Input level is -50 dBu.
You can change the input level to -60 dBu
in the setup menus, RECORDING SETUP
screen MIC GAIN1 and MIC GAIN2. (Page 56)
Be aware that sensitivity will be higher if
you choose -60 dBu so you will record more
noise.
3
When using the phantom microphone
(which requires + 48V power supply),
set the INPUT 1/2 (MIC POWER +48V)
switches to ON.
ON: (When using the phantom microphone)
+48V power supply to INPUT 1/2 terminals.
OFF: (When a phantom microphone is not
connected)
No power supply for INPUT 1/2 terminals.
The battery will discharge faster if you use a •
phantom microphone.
Set to OFF if you connect equipment not •
compatible with +48V. You can damage such
equipment if you leave the setting at ON.
When using the AG-MC200G (optional), set •
the MIC GAIN item to -50 dBu.