Filter
Top Products
Menu
109
Item
Display
mode
Description of settings
SD CARD FORMAT (Camera) Formats the SD memory cards.
OTHER FUNCTIONS screen
Item
Display
mode
Description of settings
USER FILE (Camera)
(MCR)
LOAD:
Loads the settings in a previously stored user le.
SAVE:
Saves the updated user le settings.
INITIAL:
Returns the user settings in the user le to the factory settings.
After a LOAD or INITIAL operation, turn the POWER switch off and
then back on again to make the new settings available.
An INITIAL operation does not change the TIME ZONE settings
(Page 110).
•
REMOTE (Camera)
(MCR)
Sets the operations of the supplied remote control unit. (Remote control
setup. (Page 17))
OFF:
Operations are not accepted from any remote control.
1:
Accepts commands from the remote control set for “operation mode 1”
2:
Accepts commands from the remote control set for “operation mode 2”.
1394 CONTROL (Camera) Sets the control method for backup recording using a backup unit
connected to the 1394 terminal.
OFF:
The backup unit is not controlled.
EXT:
The backup unit can be controlled by the START/STOP button. The
images shot by the camera recorder are recorded by the backup unit.
Note that the camera recorder does not record them.
BOTH:
The images shot by the camera recorder are recorded by both the
camera recorder and backup unit.
CHAIN:
When the camera recorder’s media approaches its end during
shooting, the backup unit in the recording stand-by mode automatically
starts recording images.
1394 CMD SEL (Camera) Sets how the START/STOP button works for the backup unit.
REC_P:
This switches between recording and pause.
STOP:
This switches between recording and stop.
<Note>
If the backup unit does not have a rec pause function, select STOP.
PC MODE (Camera)
(MCR)
Selects the terminal for data transfer. (You cannot select USB and 1394
at the same time.)
USB DEVICE:
Mode for sending les using the USB connector.
1394 DEVICE:
Mode for sending les using the 1394 connector.
1394 HOST:
Mode for copying les from the P2 card onto an external hard disk drive
using the 1394 connector.
___indicates the factory setting.
CARD FUNCTIONS screen (continued)