Filter
Top Products
Editing
83
To check the HDD status
The color of indicates the HDD status, as
below.
White: HDD is connected and can be used.
Black: HDD is not connected.
Red: Copy cannot be made to the HDD since it is
incorrectly formatted, etc.
When the color is red, correctly format the HDD
at step 5 before copying data onto it.
To check the data copied into the hard disk
drive
After completing step 4 on the previous page, push
the Operation lever in the
e
or
r
direction to select
PROPERTY and press it again.
The contents of the hard disk drive are displayed.
To view detailed hard disk data, push the
Operation lever in the
e
or
r
direction to select
an item and press it again.
To verify the data when copying it into the hard
disk drive
After completing step 4 on the previous page, push
the Operation lever in the
e
or
r
direction to select
YES for the VERIFY option under SETUP.
Copying to the P2 card is completed, even if you
interrupt processing during verication.
•
•
•
You cannot copy data from the hard disk drive
to a P2 card.
Use a hard disk drive under the following
conditions.
Power is supplied from a source other than
the 1394 bus. (It is not supplied from the
unit.)
You may format the hard disk drive for
usage by the unit.
Use the hard disk drive within the
guaranteed operating range (humidity and
other environmental conditions).
Do not place the hard disk drive in an
unstable locations or locations subjected to
vibrations.
Some HDD may not operate correctly.
During formatting or copying, do not remove
any cables, eject the P2 card, or turn off the
power for the unit or hard disk drive. The
power will need to be turned on again.
No guarantees are made for operation if the
1394 HOST mode is established without
rst connecting the HDD (1394.a SBP2
supported) and then the HDD is connected. In
this case, turn off the power, and then release
the 1394 HOST mode.
The hard disk drive is an extremely
highprecision device. Therefore, it is
highly possible that data cannot be read in
certain operating environments.
Please note that our company will not be
liable for any data losses due to hard disk
drive failure or other faults, or any other
direct or indirect damage related to these
problems.
If you rewrite the contents of the HDD
used to carry out copying from the camera
to another PC, the subsequent operation
in the camera and the data in the HDD
cannot be guaranteed.
It is recommended that you rst restore any
defective clips contained in the P2 card before
copying the data.
In order to avoid the occurrence of trouble in
copying, formatting or other operations, it is
recommended that you perform these operations
after ensuring that power supply has stabilized.
•
•
•
•
•
•
•
•
•
•
•
•
•
•