Filter
Top Products
Shooting
55
6 Press the MENU button four times to cancel
the menu mode.
To load a le
1) Perform steps 1 to 3, select READ in step 4
and push the Operation lever.
When reading is completed, READ OK
appears.
To title a le
1) Perform steps 1 to 4.
2) Push the Operation lever in the
e
or
r
direction to select a character, then push it in
the
q
direction to move to the next character.
(The next character can now be selected.)
You can input any of the following characters:
Space, A to Z, 0 to 9, : ; < = > ? @ [ \ ] ^_-./
You can erase all characters using the
RESET button on the camera or the remote
control.
Camera or Remote control
BARS
CH1 SELECT
RESET/TC SET
REC
CH2 SELECT
AUDIO
INT(L)
INPUT1
INPUT2
SHUTTER
SPEES SELECT
INT(R)
INPUT2
INPUT1
MIC POWER+48V
ON
OFF
INPUT2
ON
OFF
LCD
ZEBRA
EVF DTL
OIS
WFM
OSD
COUNTER
RESET TITLE
VOL +
MULTI/
P-IN-P
REC A.DUB
PLAY/REW FF/
ZOOM
DATE/
TIME
PHOTO
SHOT
START/
STOP
-
COUNTER
3) When all characters have been entered, push
the Operation lever in the
w
direction at the left
end (or in
q
direction at the right end) of the
characters. Then press the Operation lever .
To reload a le from an SD memory card
1) Perform steps 1 and 2.
2) Push the Operation lever in the
e
or
r
direction to move to TITLE RELOAD, display
YES and press it again.
The le reloads.
If WRITE NG FORMAT ERROR appears,
format the SD memory card. (Page 28)
If WRITE NG WRITE PROTECT appears,
release the protected status of the SD
memory card.
If WRITE NG CANNOT ACCESS appears,
quit all other operations (such as playback)
before proceeding.
If WRITE NG ERROR appears, the SD
memory card may be defective. Replace it.
•
•
•
•
•
•