Panasonic WV-CS854A Security Camera User Manual


 
40
3. After selecting LL, press the CAM (SET) key.
The SYNC menu appears on the monitor screen.
4. Supply the video output signal of the camera to be adjusted and
the reference camera video output signal (for example, Camera 1)
to a dual-trace oscilloscope.
5. Set the dual-trace oscilloscope to the vertical rate and expand the
vertical sync portion on the oscilloscope.
6. Move the cursor to COARSE by using the joystick.
7. Use the joystick to match the vertical phases for both video output
signals as closely as possible. (COARSE adjustment can be
incremented in steps of 22.5 degrees (16 steps) with the joystick.)
** SYNC **
V PHASE
COARSE
FINE
RET
1(1--16)
|•••••••
- +
** SYNC **
V PHASE
COARSE
FINE
RET
1(1--16)
|•••••••
- +
SYNC menu
1 (1 - - - 16): 0 degrees
2 (1 - - - 16): 22.5 degrees
16 (1 - - - 16): 337.5 degrees
Note: After the 16 steps, the adjustment returns to the first step.
8. Move the cursor to FINE by using the joystick.
9. Use the joystick to match the vertical phase for both video output
signals as closely as possible.
Notes:
When the | cursor reaches the + end, it jumps back to “–”.
At the same time, COARSE is incremented by one step to
enable a continuous adjustment. The reverse takes place
when the | cursor reaches the “–” end.
When the joystick is kept to the right or left for one second or
more, the | cursor moves quickly.
To reset COARSE and FINE to the preset values at the factory,
press the F2 button of the WV-CU550B. (For the WV-RM70,
press the Right and Left switches simultaneously.) COARSE is
preset at the factory to zero-crossing of the AC line phase.
If the AC line contains noise (spike noise, etc.), the stability of
the vertical phase of the camera video output signal may be
disturbed.
8. White Balance Setting (WHITE BAL)
(1) Auto-Tracing White Balance Mode (ATW)
The menu screens follow the example for WV-CS854A.
1. Display SET UP on the monitor screen.
(Refer to Setup Menu Display on page 16 for details on displaying
the SET UP menu on the monitor screen.)
** SYNC **
V PHASE
COARSE
FINE
RET
4(1--16)
••••••|••
- +
** SYNC **
V PHASE
COARSE
FINE
RET
1(1--16)
|•••••••
- +
** SET UP **
CAMERA ID
ALC/MANUAL
SHUTTER
AGC
SENS UP
SYNC
WHITE BAL
MOTION DET
AF MODE
RET SPECIAL2
OFF
ALC
OFF
ON(MID)
X2 AUTO
INT
ATW
OFF
MANUAL M
Camera setting menu