Panasonic DMC-FT1 Digital Camera User Manual


 
VQT1Z66
10
Before Use
Confirm that there is no foreign object
In the areas adjacent to location B, please be sure that no droplets of water are present before
opening the battery door.
Before closing the card/battery door or terminal cover, confirm that there are no foreign objects
(hair, lint, sand, dust, fluid, etc.) on the part (B and C) coloured black in the figure. When the
camera is used underwater with foreign objects clamped on the card/battery door or the
terminal cover, water may leak in, causing a malfunction.
Wipe it off with a dry soft cloth if there is any liquid.
If there is any foreign object, remove it with attached brush.
If there is any crack or deformation in the area coloured black in the figure, contact Panasonic’s
Service Centre.
Keep the Brush out of reach of children to prevent swallowing.
Securely close the SD card/battery door and terminal cover
Using the camera underwater
This camera can be used under water to a depth not exceeding 3 m, where the water temperature is
between 0
o
C
to 40
o
C
and not longer than 60 minutes continuously.
If there is water or dirt on the camera, use it after wiping it off with a dry soft cloth and dried in a
well ventilated area.
Do not open or close the card/battery door or terminal cover.
Do not apply shock to the camera underwater. (Waterproof performance may not be
maintained, and there is a chance of water leak.)
Do not dive into the water holding the camera. Do not use the camera at the location where the
water will splash strongly, such as rapid flow or waterfall. (Strong water pressure may be
applied, and it may cause malfunction.)
The camera will sink in the water. Take care not to drop the camera and lose it underwater by
securely placing the hand strap around your wrist or similar measure.
Do not use in water that exceeds 40
o
C such as in baths, hot tubs, spas and hot springs.
When the camera is splashed with detergent, soap, hot spring, bath additive, sun oil, sun
screen, chemical, etc., wipe it off immediately.
Card and battery are not waterproof. Do not handle with a wet hand. Also, do not insert wet
card or battery into the camera.
A Card/Battery door
B Rubber seal
C Area where rubber seal sits
D Terminal cover
E Hair and lint
F
Sand and dust
G Crack and deformation
H
Fluid
I Brush (supplied)
A Red part
To prevent water leakage please check very
carefully that no foreign object such as sand,
hair, dust or fluid is present anywhere within
the area of the door seal and door. Close the
door by pressing it firmly until it clicks. Confirm
that the “red” area on the lock tab is not visible.
VQT1Z66~Body1_mst.fm 10 ページ 2009年2月3日 火曜日 午後9時41分