Filter
Top Products
11
VQT1Z66
Before Use
∫ Caring of the camera after using it underwater
∫ Replacing the waterproof seal
•
The integrity of the waterproof seals may decrease after about 1 year, with use and age. To
avoid permanently damaging the camera the seals should be replaced once each year. Please
contact Panasonic’s Service Centre for related costs and other information.
• After all underwater use, dry the camera thoroughly,
as quickly as possible using a lint free cloth. This must
be done within 60 minutes of use, or the waterproof
seals may be damaged.
• If the camera was used in salt water the camera must
be thoroughly rinsed and cleansed as quickly as
possible. It’s recommended that it is first rinsed with
fresh water, then submersed in fresh water in a
shallow container for about 10 minutes. When the
camera is removed, thoroughly dry it.
• Droplets of water may collect in the area around the battery door. Before opening the door
make sure this area is water-free.
• This camera has a water drain that allows water that has accumulated under the plastic trim to
drain. This may continue for up to 10 minutes, even after the camera is dried. You can place the
camera in a vertical position on a dry cloth during this time.
• If the zoom lever or mode dial does not move smoothly, it may be caused by the adhesion of
foreign objects. It may cause malfunctions, such as locking up, so wash off any foreign objects
on the zoom lever or mode dial by shaking the camera in fresh water. Confirm that the zoom
lever and mode dial moves smoothly after cleaning.
• After soaking or washing the unit, wipe off water drops with a dry soft cloth and dry the unit in
an area of shade with a draft.
• This unit incorporates drain design, draining water in gaps in the power button and zoom lever
etc. As a result of this, bubbles may come out when you soak the unit in water, but it is not a
malfunction. Make sure that water is completely drained from the unit after soaking in water by
standing the unit on a dry cloth for a while.
• Do not dry the camera with hot air from dryer or similar. Waterproof performance will deteriorate
due to deformation.
• Do not use chemicals, such as benzine, thinner, or alcohol, soap, detergents.
DMC-FT1&TS1GN-VQT1Z66_eng.book 11 ページ ２００９年２月３日 火曜日 午後４時１０分