Filter
Top Products
143
VQT1Z66
Others
> Disconnect the USB connection cable. Connect it again while the card is inserted in the
camera.
• When the mode dial is set to [¨], contents of the built-in memory will be displayed.
> Set the mode dial to anything except [¨].
• Pictures cannot be printed using a printer which does not support PictBridge.
> Set to [PictBridge(PTP)] in [USB MODE]. (P30, 124)
> When using a printer with a trimming or borderless printing function, cancel this function
before printing. (For details, refer to the operating instructions for the printer.)
> When you order photo studios to print pictures, ask the photo studio if the pictures can be
printed with both ends.
> Press [MENU/SET], select the [SETUP] menu icon [ ] and then select the [~] icon to set
the desired language. (P32)
• AF assist lamp (P93) will turn on white in the dark place to assist the focusing.
• Is [AF ASSIST LAMP] on the [REC] mode menu set to [ON]? (P93)
• The AF assist lamp does not turn on in bright places.
• The surface of the camera may become warm during use. This does not affect the performance
or quality of the camera.
• The temperature of the camera may fall and the camera parts may not work well if you leave it
as it is after taking it out of water, snow etc. following use in a cold environment such as low
temperature water or on a snow-covered mountain etc. This is not a malfunction. The camera
will recover after returning to normal temperature.
• When the brightness changes due to zoom or camera movement etc., the lens may click and
the picture on the screen may drastically change. However, the picture is not affected. The
sound is caused by the automatic adjustment of the aperture. This is not a malfunction.
The card is not recognised by the PC. (The built-in memory is recognised.)
The picture cannot be printed when the camera is connected to a printer.
The ends of the pictures are cut at printing.
Others
An unreadable language was selected by mistake.
White lamp may come on when the shutter button is pressed halfway.
The AF assist lamp does not turn on.
The camera becomes warm.
A part of the camera such as the zoom lever and card/battery door, and terminal
cover does not move.
The lens clicks.
DMC-FT1&TS1GN-VQT1Z66_eng.book 143 ページ ２００９年２月３日 火曜日 午後４時１０分