Filter
Top Products
VQT1Z66
20
Preparation
∫ About the card/battery door.
If you turn on the power with the card/battery door open, a warning sound will go off in order
to avoid immersion and the message shown below will appear on the LCD monitor. (P136)
The camera cannot be operated when the card/battery door is open. (Only the ON/OFF
button can be operated) Close it securely so no foreign object is clamped.
•
Messages are not displayed when the terminal cover is opened. Also, the camera can be
operated, but close the cover securely so no foreign object is clamped before using the
camera.
If there is any foreign object, remove it with attached brush.
∫ Connecting the AC adaptor and multi conversion adaptor instead of the battery
Always purchase the AC adaptor (DMW-AC5G; optional) and the multi conversion adaptor
(DMW-MCA1; optional) as a set. The AC adaptor (DMW-AC5G; optional) cannot be used
by itself. Also, read the instruction for the multi conversion adaptor (DMW-MCA1; optional)
regarding the connection.
1 Open the terminal cover
2 Connect the camera with the multi conversion adaptor (DMW-MCA1; optional)
•
Ensure that only the AC adaptor (DMW-AC5G; optional) and multi conversion adaptor
(DMW-MCA1; optional)
for this camera are used. Using any other equipment may cause
damage.
3 Connect the AC mains lead to the AC adaptor and a wall outlet.
4 Connect the AC adaptor to the multi conversion adaptor.
Note
•
Always use a genuine Panasonic AC adaptor (DMW-AC5G; optional).
• Always use a genuine Panasonic multi conversion adaptor (DMW-MCA1; optional).
BATTERY COVER OPEN
CHECK THAT NO SAND,
HAIR, OR OTHER OBJECTS
ARE ON THE DOOR SEAL.
DMC-FT1&TS1GN-VQT1Z66_eng.book 20 ページ ２００９年２月３日 火曜日 午後４時１０分