Panasonic VDR-D100 Camcorder User Manual


 
106
LSQT0969
Connection and recognition (Windows)
With a computer (VDR-D200 only)
Connection and recognition (Windows)
After the driver and software applications are installed, the unit must be connected to the computer
and be correctly recognized by the computer.
Connect after installing the driver and software applications.
If the supplied CD-ROM is inserted in the computer, remove it. (If the [Setup Menu] is running,
wait until it finishes, then remove the CD-ROM.)
If the recognition procedure is not accomplished properly, operation will not be possible after
connecting the unit to the computer.
If the unit fails to operate normally, it may mean that you have not conducted the installation or
recognition procedure properly.
¬Connect this unit to the AC adaptor.
1 Insert a disc or card with recorded images in the unit, then select the
unit’s operation mode.
When using a disc: Select .
When using a card: Select .
2 (Only in card playback mode)
Press the MENU button, then select [ SETUP] #
[ USB FUNCTION] # [PC CONNECT] and press
the joystick.
Press the MENU button to exit the menu screen.
3 Connect this unit and a computer.
This unit is automatically recognized by the
computer.
Do not use any other USB cables except the
supplied one. (Operation is not guaranteed with any
other USB cables.)
Connection and recognition procedures
A USB cable (supplied)
Insert the plugs as far as they will go. The unit
and computer will not operate properly if the
plugs are not inserted fully.
A
D200(P_PC)eng.book 106 ページ 2006年1月18日 水曜日 午後5時46分