122
LSQT0969
Using discs on a computer (Macintosh)
With a computer (VDR-D200 only)
12 Click [Create Menu] (A) and edit the DVD menu as
required, then click [Write to Disc] (B).
13 Check [Create disc] (A), select the drive to be
used (B) and then click [Write] (C).
14 Insert a brand-new 12 cm (5z) DVD-RW or DVD-R disc into
the disc drive and click [OK].
≥ 12 cm (5z) iRW and iR discs can also be used if the disc drive supports them.
15 Proceed with the write setting and then click [OK].
Writing to the disc starts.
≥ Depending on the amount of data, writing to the disc may take time.
≥ When the unit is connected to a computer, the
operation mode cannot be changed and its
power cannot be turned off.
In this case, disconnect the USB cable (l below).
≥ When the unit is connected to a computer in disc
playback mode, no image will appear on the LCD
monitor or viewfinder.
≥ When this unit is connected to a computer, you
cannot use this unit’s DISC EJECT lever to remove
a disc. Use the software’s eject button to eject the
disc.
≥ When a computer is accessing a disc in this unit,
the ACCESS/PC lamp lights. Do not disconnect the
USB cable or AC adaptor while the disc is being
accessed as it may damage the data.
When the drive icon is displayed on the desktop:
Drag the icon into the Trash and then disconnect the USB cable.
When the drive icon is not displayed on the desktop:
Exit the application and then disconnect the USB cable.
≥ If you disconnect the USB cable while the access
lamp is on, it may damage the data.
A
B
A
B
C
To disconnect USB cable safely
D200(P_PC)eng.book 122 ページ 2006年1月18日 水曜日 午後5時46分