Filter
Top Products
140
LSQT0969
Troubleshooting
Others
Problem Check points
DVD-RAM or DVD-RW
(VR format) icon is not
displayed on the desktop.
≥ What version of Mac OS X are you using? If it is V10.3.x or
earlier, the icon is not displayed even if the disc is
recognized by the computer. Use Disk Utility or Apple
System Profiler to verify if the disc is recognized by the
computer.
When Pixe VRF Browser
EX is started, a message
is displayed about
ejecting the disc.
≥ Is there a disc in this unit when Pixe VRF Browser EX is
started?
# Insert the disc after starting Pixe VRF Browser EX.
Cannot register the file
with ImageMixer VCD/
DVD2.
≥ Is there a file with a compatible format in the folder? Check
the help for ImageMixer VCD/DVD2.
≥ In [Options] in the [Select folder], confirm the small box for
[Add sub-folder(s)] is checked.
≥ The same folder cannot be selected simultaneously in
DVD-Video mode and Video CD mode. In [Selected
folder(s)] for the mode not being used, delete the folder.
Cannot select this unit as
the write destination
drive with ImageMixer
VCD/DVD2.
≥ Cannot write to this unit with ImageMixer VCD/DVD2.
# To create a DVD-Video disc, a separate DVD-RW/DVD-R/
+RW/+R drive is required.
The disc for writing is not
recognized by
ImageMixer VCD/DVD2.
≥ If there is a disc in the drive before ImageMixer VCD/DVD2
is started, the drive will not be recognized properly.
# 1) Click the upper-right save icon and save the settings.
2) Exit from ImageMixer VCD/DVD2 and remove the disc.
3) Start ImageMixer VCD/DVD2 again, click the [Load
Project] button to read the file with the saved settings.
4) Proceed with [Write to Disc] again.
The message [There is no
work disk space.] is
displayed and the data
cannot write to disc.
≥ There is not enough work space to write to the disc.
# Click the [Preferences] button on the upper-right of
ImageMixer VCD/DVD2 and select a work space with a large
amount of free space.
The DISC EJECT lever
does not work when the
unit is connected to the
computer.
≥ The DISC EJECT lever does not work after the unit is
connected to the computer. Use the software’s eject button
to eject the disc.
When the USB cable is
disconnected, an error
message will appear on
the computer.
≥ When the drive icon is displayed on the desktop, drag the
icon into the Trash and then disconnect the USB cable.
≥ When the drive icon is not displayed on the desktop, exit
the application and then disconnect the USB cable.
D200(P_PC)eng.book 140 ページ ２００６年１月１８日 水曜日 午後５時４６分