Filter
Top Products
41
LSQT0969
Recording
Recording motion pictures
Recording motion pictures
(RAM) (-RW‹VR›) (-RW‹V›) (-R)
Record motion pictures onto a disc.
1 Remove the lens cap, then turn the unit on.
If the unit is turned on with the lens cap fitted, the automatic white balance adjustment may not
function properly.
2 Rotate the mode dial to select .
3 Press the recording start/stop
button to start recording.
To end the recording
Press the recording start/stop button again to
pause recording.
≥ [¥] and [;] are red during recording. Do not
move this unit until [;] is green.
≥ The images recorded between pressing the recording start/stop button to start recording and
pressing it again to pause recording become one scene.
≥ When about 5 minutes has passed without any operation, this unit automatically turns off to
prevent the battery from running down. When you use this unit, turn it on again.
This setting can also be set to [OFF]. (l 127, POWER SAVE)
≥ The maximum number of scenes on a disc (per
side): 999 (Even if there is remaining capacity for
recording on a disc, you may not be able to record
999 scenes.)
≥ While “WRITING THE INFORMATION ON THE
DISC.” is displayed, do not disconnect the AC cable
or remove the battery as doing so may make the
disc unusable.
≥ Sound is recorded in Dolby Digital from the internal
stereo microphone on the front of the unit. Take
care not to block this microphone.
≥ Each time the unit enters the recording pause
mode, the counter display will be reset to
“0h00m00s”.
D200(P_PC)eng.book 41 ページ ２００６年１月１８日 水曜日 午後５時４６分