Filter
Top Products
Basic Operation
27
Basic Operation
POWER Switch
Set the POWER Switch to REC or
MANUAL REC. (See pages 18, 19.)
Before you begin
RapidFire™ Picture Taking
1Press REC MODE repeatedly to
select recording mode (SF, F, N).
(See page 25.)
• If the REC mode is set to ZOOM (2X,
3X),
, or TIFF mode, change
REC mode. (See page 25.)
2Press MENU to display the MENU
screen. Press
or to select RAPID
in the MENU screen, and press
or
to select ON.
3Press MENU to exit.
• If you select ON, “RAPID” is displayed
on the screen.
• RapidFire™ Page Remaining is
displayed on the screen.
4Press SHTR to capture the image.
• When page remaining becomes zero,
or when you change modes (e.g.
REC-->MANUAL REC), images are
automatically saved to the Disk
Media.
3MENU Button
2Select
Button
/ / /
Caution
• If the Battery becomes depleted with
image data not saved to the Disk Media,
the image data will be lost. Always
confirm the Battery condition before
capturing images.
With this feature, captured images are first
stored in Camera memory. This speeds up
the processing time and allows you to
capture the next image right away.
Capturing Images
Capturing Images
[ REC mode ] [ MANUAL REC mode ]
RapidFire™
Page Remain
1REC
MODE Button
• The Disk Media cannot be ejected until after the
memory data has been written. Press (+)
button to write the memory data to the Disk
Media, then eject the Disk Media.
• Camera memory capacity is: 3 frames in SF
mode, 4 frames in FINE mode, and 12 frames
in NORMAL mode. While the Digital Camera
processes the images “REC” will flash on the
LCD Viewfinder, no further images can be
captured while REC is flashing.
• If there are images left in Camera memory
when the power is turned off, the images are
saved to the Disk Media and then power
goes off.
• To save images in Camera memory to the Disk
Media at any time, press the (+) button.
• Images stored in Camera memory cannot be
deleted. Save the images to the Disk Media,
then refer to page 41 (To Delete Specific
Images).
Note
• AUDIO, SELF TIMER and TIME LAPSE
functions are automatically disabled when
RAPIDFIRE™ is set to ON.
Note
SD5000. p25-28.p65 80/01/04, 11:3927