Filter
Top Products
25
LSQT1190
Setup
Setup
Power supply
When this unit is purchased, the battery is not
charged. Charge the battery before using this
unit.
≥ If the DC cable is connected to the AC
adaptor, then the battery will not be
charged. Remove the DC cable from the AC
adaptor.
1 Connect the AC cable to the AC
adaptor and the AC outlet.
2 Put the battery on the battery
mount by aligning the mark, and
then securely plug it in.
≥ The output plug of the AC cable is not
completely connected to the AC adaptor jack.
As shown in A, there is a gap.
∫ Charging lamp
≥ Battery charging time (l 26)
≥ We recommend using Panasonic batteries.
(l 15, 129)
≥ If you use other batteries, we cannot guarantee
the quality of this product.
Push the battery against the battery
holder and slide it until it clicks.
While sliding the BATTERY lever,
slide the battery to remove it.
≥ Hold the battery with your hand so it does not
fall.
≥ Before removing the battery, be sure to set the
OFF/ON switch to OFF and check that the
status indicator is off.
Charging the battery
Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged
(discharged excessively). In a while,
the lamp will light up and normal
charging will start.
When the battery temperature is
excessively high or low, the
CHARGE lamp flashes and the
charging time will be longer than
normal.
A
Inserting the battery
Removing the battery
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
LSQT1190(ENG).book 25 ページ ２００７年１月１３日 土曜日 午後３時３２分