Filter
Top Products
26 C634M-D (12/04)
CHANGING THE RECORDER’S IDENTIFICATION
The recorder name has been preset during manufacturing. The default name is Pelco1. Changing the recorder’s name should be
done through the Server Identification dialog box only.
1. Close all applications on the recorder.
2. Double-click the DX9000 Server Configuration Utility icon on the desktop. The following dialog box appears.
Figure 17. Server Identification Dialog Box
4. Enter the new computer name.
NOTE: The computer name may appear shortened if it is longer than five characters.
5. Enter the new IP address. Make sure the network cable is plugged in before changing the IP address.
6. Click Apply.
7. Click OK to restart the system.
8. Repeat steps 1-7 for all recorders.
Figure 16. Server Configuration Utility Dialog Box
3. Click Server Identification. The following dialog box appears.