Filter
Top Products
88 C634M-D (12/04)
Figure 117. CM9760-DT Configuration
7. Set the baud rate to 4800 and the parity to Even. The data translator should have these same settings.
8. Enter the COM Port number. This is the port on the viewstation that connects to the data translator.
9. Click OK.
10. Click Test.
11. Click OK on the Server Alert Configuration screen to save your settings.
NOTE: Once you complete programming, refer to the CM9760-MGR manual for instructions on macro programming for the
matrix switcher. Individual macro commands must be customized within the CM9760-MGR software to switch the appropriate
group of cameras to the monitors connected to the standby DX9200.
6. Click Configure. The following dialog box appears.